Wifi Repeater Manual

Instruction Manual 3 Installation Repeater Mode Setup: 1. Connect the Repeater to an available AC electrical outlet. Wired Setup: Connect an RJ45 Ethernet cable from the Repeater to your computer. Wireless Setup: Connect to the wireless network ‘WiFi-Repeater’. The default IP address on the Repeater is 192.168.10.1; configure your. A WiFi repeater could be the solution for you. A WiFi repeater or extender is used to extend the coverage area of your WiFi network. It works by receiving your existing WiFi signal, amplifying it and then transmitting the boosted signal. With a WiFi repeater you can effectively double the coverage area of your WiFi network - reaching far. Configure the Wi-Fi Repeater Mode Configure the Wi-Fi Repeater Mode with WPS Button. This is the easiest way to configure the Device. First, check whether your wireless router supports WPS. For further details, please read the operating instructions for your wireless router.

Aigital Wifi Repeater Manual
Wifi Repeater Manual Setup

Aug 11, 2021
11805
1

Aigital Wifi Repeater Manual

You want to install a wireless Repeater in your network, you have two paths available. You can install the Repeater, either automatically or manually. We will show you in this practical tip for both methods.

Wi-Fi Repeater install with WPS method

The Installation is quick and easy. Plug the wifi Repeater into a power outlet and press and hold the WPS button on the device for a few seconds.
Appears the LED Signal on the Repeater, press you within the next 2 minutes, the WPS button on your wireless Router. These also have to hold for a few seconds, until the LED Signal appears.
Then the Repeater will automatically via wifi with the Router and is then also installed.
Not every Repeater has WPS. In this case, you can install the device manually.

Manual Installation of the Wi-Fi repeater under Windows

This way the Installation leads you through the user interface of the repeater. We will show you the procedure on the basis of a Fritz repeater.

First, you plug the wifi Repeater into the wall outlet. At best, these can be found in the vicinity of your computer. Alternatively, you can connect the Repeater via LAN cable with your PC.
On a Windows computer click next on the network icon. You can find this usually at the very bottom right.
Here you can select the Wi-Fi Repeater. It is displayed when the Repeater is plugged into the outlet. Uncheck 'connect automatically', remove the checkmark in front of it.
Then click 'Connect'. Now you need to enter the wireless Key. You can find it on the bottom of the repeater. The default setting is usually '00000000'.
Start the Browser on your Computer and call the user interface of the repeater on. The necessary IP address, refer to the manual for your repeater. In the case of a Fritz repeater, you can also enter 'http://fritz.repeater' in the address line.
Make sure that you are logged in to the Wi-Fi network to which you want the Repeater to integrate.
Login to the user interface of the repeater by setting the first password, and confirm with 'OK'. Through the next steps of the setup wizard leads you.
Select 'wireless bridge' as the access type and confirm with 'Next'.
You get to the point 'Repeater wireless network selection', put the hook in front of the Wi-Fi network by you want to mount the Repeater. Confirm again with 'Next'.
Next, the Repeater security settings follow. You choose a WPA encryption. To do this, you need to enter the 'WLAN network key' the password of your network and re-confirm with 'Next'.
It follows, assume a window with the Heading 'settings'. Click here on 'finish' to complete the Installation and setup of the repeater.
However, it may take a few minutes, until the Repeater has connected to the Router. After that, you can plug the Repeater into an outlet of your choice.

Wi-Fi-Repeater with Mac install

The installations integration of a Wi-Fi repeater in the network will not work under Mac will be much different than under Windows.